TVHeadend no input detected after a few hours

[ebatte]

After booting OE PVR 2.0 beta1 (and all previous pvr versions) live tv works fine. After a few hours I get an error "no input detected". If, after getting the error, I open the live tv stream (hdhomerun) directly using a .srtm file it works so I'm not sure why tvheadend reports no input detected.

Any suggestions to help me troubleshoot?

Thanks

[ebatte]

(polite) bump

[funkmuffin]

I'll add my voice here. This is happening on my machine too, with beta 2. Never installed beta 1. It would happen from time to time (maybe once a day, maybe not for a couple days) with daily build 9963.

Since the official beta, it's happening as often as hourly. I'm not sure what exactly is happening, but we have the same basic config -- tvheadend and hdhomerun. I'm not sure where to look in the logs, but will be happy to make available any logs that will help with troubleshooting.

It even stopped tonight in the middle of recording one of our weekly shows. That was frustrating. It always corrects after a reboot, and I'm guessing there's probably a way to recover without a full boot, but that's easier, especially for my wife and kids.

Note: I did just re-install the hdhomerun driver. I'll see how things go tomorrow -- maybe it just needed to re-install after the upgrade to beta 2.

[lindarose11]

It's very good post which I really enjoyed reading. It is not everyday that I have the possibility to see something like this.

krunker io big8games.com