Problem with installing OE4 to USB (from USB)

[nivepl]

So I thought I'll try new OE4.
In times of 3.2.4 release I took 2 usb sticks, used one as install source and other as target. Worked flawlessly, and then I could install it permanently on my ssd as main xbmc system.

So I did the same with OE4. I downloaded OpenELEC Stable - Generic x86_64 Version:4.0.0 and created install usb - no problem.
Install process - no problem. Until reboot. After reboot the system doesn't boot.
it shows message:
error in prepare_sysroot: final_check: Could not find system
Starting debugging shell… type exit to quit
sh: can’t access tty: job control off

and thats it;(( WTF!?

[rodzyneck]

Same here: http://openelec.tv/forum/64-installation...-usb-drive

Turning off hard drive controller in BIOS helps, but it;s not the right way to do it

[nivepl]

Same here: http://openelec.tv/forum/64-installation...-usb-drive

Turning off hard drive controller in BIOS helps, but it;s not the right way to do it

I'll try this but I second your comment it is a workaround but not a solution;(

I have 3 disks in my htpc, 64gb ssd for system and 1B and 2TB for movies/tvseries.
You think I can disconnect ssd only for this workaround to work? Or do I need to disconnect all disks?

[rodzyneck]

I've disabled the controller, didn't disconnect disks - I don't even know if disconnecting disks alone will work.

[nivepl]

So if you have done that, can you still access disks when OE4 is fully initiated?

[rodzyneck]

Nope That's why it's not a valid workaround I personally don't need them because i have a NAS.

[nivepl]

Great;(
I wonder if there is a way to officially report this bug to OE team? Or they just know by reading this forum?

[lrusak]

Great;(
I wonder if there is a way to officially report this bug to OE team? Or they just know by reading this forum?

I'll point it to the appropriate people. Thanks,

[nivepl]

It is still not fixed in 4.0.1. I get the same error.

[nivepl]

Can someone PLEASE look at resolving this issue?
I tried v. 4.0.2 and 4.0.3 and still no joy.
It worked perfectly in 3.2.4 so I guess there's easy workaround to it.

I would love to try new OE before the big switch and usb to usb install was perfect for this.

Thanks in advance!