TV Tuner Adapter not available

[jocrow]

Equipment
CuBox-i4Pro
Kworld UB435-Q
Openelec 5.0.8

I am trying to install the TV tuner card listed above on my CuBox. The adapter does not show up as an available adapter in Tvheadend. For troubleshoot I tried the same setup on a RaspberryPi (RaspberryPi B+, OpenElec 5.0.8) and the card shows up in tvheadend. The card is listed as a supported devices according to openelec wiki.

I have done some troubleshoot but I have little linux experience. It appears that the CuBox recognizes the USB adapter as installed but never loads a driver. I have attached the outputs for lsusb, dmesg for both the CuBox and RaspberryPi. Any help would be appreciated.

[grillz]

Nothing was attached.

Try:
lsusb -v | pastebinit
and
dmesg | pastebinit

That will put logs on pastebin for people to look at.

[trsqr]

The kernel on the cuboxi is 3.14 if I don't remember incorrectly. All the other flavours do use a fresh kernel. There's a good chance that the UB435-Q you have is one of the more recent versions (there are 3 different versions) and thus not supported by the 3.14 kernel...

[jocrow]

Thank you for the response. I checked and you are correct the CuBox uses the 3.14.36 kernel and the RPi uses the 3.17.8 version. I believe when I looked I did have the version 3 of the TV adapter.

At this point I am willing to wait for the next version of OE specially since they announce the beta version today. I assume the CuBox will get upgraded to a new version of the kernel at that point.

[jocrow]

Thank you for the reply. Based on the other reply I got I am going to wait and troubleshoot after I can upgrade to the next version of OE.