04-24-2016, 09:40 AM
I´ve made an upgrade to openelec 7.0 beta 2 in order to get bluetooth audio support. I followed the steps shown in the Openelec webpage (http://openelec.tv/news/22-releases/179-...2-released) to enable and use bluetooth audio support. And I really can pair the raspberry pi 2 with my bluetooth headset. And openelec can connect with the headset and the headset starts to work, but only for a few seconds...that's when the connection fails and openelec informs that the bluetooth is disabled, but when I go to check if the bluetooth service is disabled, it isn´t, really. But in order to get the bluetooth working again, I have to disable it and enable again. After I do that, the headset is recognized again, I can pair it (after I turn it on) and the headset will start to work again, but only for few seconds. After that, the connection fails again...and cycle repeats...
If the headset would not be recognized and work (although just for a few seconds), I would think that it was compatibility issue between raspberry/openelec and the dongle (an Ínateck 4.0 adapter). But everything seems to be ok, because the bluetooth headset really starts to work...but, two or three second after, the connection is lost.
Thanks for your attention. Regards
If the headset would not be recognized and work (although just for a few seconds), I would think that it was compatibility issue between raspberry/openelec and the dongle (an Ínateck 4.0 adapter). But everything seems to be ok, because the bluetooth headset really starts to work...but, two or three second after, the connection is lost.
Thanks for your attention. Regards